the phos

know the difference #electronics

I don’t want to decide my gender just let me piss

Yes this is the catheter standard, yes I need it for "work reasons", no I will not elaborate

Update: we’ve watched it leave the train, go to a grocery store, and then back to the residential building next to Westbahnhof. We are very sure that location is accurate. We’ll put up posters there. We are still unsure what that means. A train attendant taking it with them seems the most likely, but why they couldn’t hand it to Lost&Found is a mystery. If they wanted to steal it taking it with them to work seems pointless. If they’re not a train attendant it doesn’t make sense why it’d be on trains for most of the day. In any case, a poster on their front door with clear contact info and maybe a reward would make it easier for them

@robryk@qoto.org for a day or so it was at Vienna Westbahnhof. Tracking showed it in a residential building right next to the Bahnhof, but not sure if that was actually the location or just where the devices pinging it from were. Looked around there but with hundreds of units, in the circle all we could do is ask people walking by if they found it, and again given it was right next to a Bahnhof maybe the location was just slight off. Today we found which line it was on, but it stopped at HBF instead of continuing on that line, and when we caught the train at its final station the train driver of that one didn’t know anything. An hour or so after it went off in a different direction from HBF. We will see where it stays tonight, but even if we go to its location all we can do is ask people about it. It’s quite infuriating to know it’s probably within 50m of you but you can’t actually find it. And especially with infrequent pings it’s hard to know which train it’s on before it’s off in the distance.

​​ Free Lathe looking for a good home! Location: Hohenau an der March, lower Austria Do your hackerspace (or you) want a lathe? I am moving soon, and I don’t think I will be able to take it with me, so I want to find my Paulimot PM3800 a new home. It weighs around 300kg, + 50 for the base, 6 speed spindle gearbox, power feed in both axis, change gears for threading, all still there. Comes with a 3 jaw and a 4 jaw, which needs a mounting plate tho, set of indexable turning tools with inserts, live and dead center, 2 ER32 tail stock drill holders with a full collet set. Bought it new around 2020, probably less than 200 hours on it, protected from grinding dust so should be in decent condition. Also bar stock in steel, aluminium, brass and bronze. Optionally if you want to tinker: A VFD, Masso CNC controller, and 2 300w servo motors. There is an engine hoist for lifting it off the base, and into a car or trailer, you do need to get it up a steep ramp for about a meter, but there is a hardpoint at the top for setting up rope and pulley or similar. I guess a few very strong people could also just lift it up the few steps. I would like to get it out of here quickly, ideally this weekend or early next week, if possible. #lathe #hackerspace #austria

@4censord@unfug.social hiii :3