marginally_constructive

First print successful! 🎉 #voron #trident #3dprinting #success

My Voron Trident is now running! 😀 The printer is accessible via the web interface and so far everything seems fine. The touch screen is disconnected for now, I think something shortened out, it is probably dead. Next up: Going through the initial startup checklist! #voron #trident #3dprinting

The touchscreen display is now installed, KlipperScreen is running and -- after several struggling attempts -- the displays is in the correct orientation! To make a long story short: If you want to use KlipperScreen, it may be best to install RaspberryPi OS and manually install all the Klipper / Moonraker / Mainsail packages... #voron #trident #klipper #klipperscreen #3dprinting

Heightmap of the (cold) printbed of my new Voron Trident. Span: 0.169 mm. Not great, not terrible... #voron #trident #3dprinting

I removed the protective film from the panels and doors - what a beautiful device! The only item missing is the touch screen at the printer base. The LDO kit also includes a Nevermore kit, which will be installed in the future... #voron #trident #3dprinting

Panels and doors installed! #voron #trident #3dprinting

Bed and nozzle can be heated, temperature readings are nominal. The controller fan won't turn on when it should be, but that should be an easy fix... #voron #trident #3dprinting #thermal

I installed the Nevermore V5 Duo (activated carbon filter). Mechanical installation and Klipper configuration (printer.conf) was a piece of cake - remembering to install the voltage selection jumper on the controller board not so much... #voron #trident #nevermore #3dprinting

For someone who is used to work with a quirky Ender-3, this machine is surprisingly fast... #voron #trident #3dprinting #benchy

Finally! The replacement for my broken touchscreen display arrived! #voron #trident #3dprinting

@frenshape@beige.party "I have made an extremely s̶i̶l̶l̶y̶ 𝘣𝘦𝘢𝘶𝘵𝘪𝘧𝘶𝘭 object using #FreeCad"

Starting a new adventure! I bought an LDO-Kit for a Voron Trident. This will be a great update from my trusty, yet old Ender-3. Looking forward to the challenge.

@amd@gts.amd.im Thank you, I didn't know! I have briefly read about scorch, but my trusted supplier didn't have it in stock, so I found it not to be urgent enough... I never printed ABS so your hint is very welcome!

@jjacobsson@mastodon.gamedev.place Very nice! Did you use magnets for the lid? I always wanted to try that, but was afraid it wouldn't be strong enough...