Next stop: Zurich @Modula26
Remote
Slash
@slash@merveilles.town
hometown 4.2.17+hometown-1.1.2
194 Followers
209 Following
18 Posts
Joined April 30, 2024
🎛️:
IRC:
irc.auti.sm
I've been holding off on showing this for a while, but I've been working on some Eurorack modules over the past few months. I just found out that I will be able to present them at Superbooth this year.
Going to try and grind out 2 more modules I have in the works by then...
Sick computer (literally) logo by @rek@merveilles.town
TFW you accidentally turn on Colemak and start printing pages 100's of times
Pretty happy with this soldering station. All variable driven. Holder for sponge, and bar to hang solder wire.
Mono channel strip with trim, gain, vactrol (photo resistor cv control), tilt eq and a master fader. Uses the same op-amp chips that are in Tascam Portastudios cause they sound good/bad. With a bit more added overdrive...
Replying to on post.lurk.org
@paupowpow@post.lurk.org @offline@autonomous.zone @ojack@post.lurk.org @bgola@m.muito.top
Made a little screen capture of the stuff I had a go at showing last night
Going to take part in #pifcamp this year in Slovenia 🎛️
https://www.youtube.com/live/mAGg1kQtWXk live code VR
orca+sunvox in VR microjam
Replying to
@aartaka They use formantic for a lot of that functionality, I'd argue much of it is detrimental. I was so annoyed by over-eager form tooltips that I had to disable them all together.
Shiver Electronics _Soultrade_ 2002 _Austria _[widerstand 10/lp 02]
Interesting watch: Evolution of Blanka Electricity (1991-2020) https://www.youtube.com/watch?v=0WUl-GN9Roo #theObservatory
Replying to
@t36s@social.ordinal.garden it took me way too much fussing about to get these 3d model footprints working, but I'm p happy with it atm. One thing I wish kicad made easier was getting a decent stacked board view working...