tristanC

I created a new #OSC based control surface implementation for #REAPER using the sdk:) https://codeberg.org/TristanCacqueray/reaper-csurf-osc-ng

The default OSC service was not working well for my needs and I'm glad it is in fact possible to change it!

I think my first PCB is now completed:) I pushed the KiCAD project here: https://codeberg.org/TristanCacqueray/clash-osc/src/branch/main/schematics/tang-nano-host

I printed a bunch of knob designs I made in openscad:)

One revision and a couple of bad solder joints later, I finally got my control surface prototype to work!

I made a new pcb to fix an issue with my first design: I needed to use 74hc03 open drain gates to fully isolate coders and avoid ghost contacts. I'm half-way through adapting my perfboard and I just posted some pictures on this page:) https://midirus.com/project/clash-osc

KiCad is a lot of fun, it sometimes feel like factorio!

I made a custom footprint for the pec16 coder:)

I renamed my hardware project and updated its page with the latest update, introducing opdo: https://midirus.com/project/opdo

Experimenting with OpenSCAD to design a knob cap:)

I routed half of the coder board. This is a bit tedious, and I hope I'm not making too many errors. KiCad is really fun though:D